Why is the step-up transformer of the ozone machine always easy to burn out, and the high-voltage package for the ozone machine is easy to burn out

Why is the step-up transformer of the ozone machine always easy to burn out, and the high-voltage package for the ozone machine is easy to burn out

The ozone machine is the latest black technology on the market. It generates super-oxygen molecules through natural high-voltage discharge to decompose formaldehyde and quickly and completely remove formaldehyde. In addition to removing formaldehyde, it can also kill more than 99% of common germs on the market. In addition to staying in new houses, In addition to driving a new car, it can also be used to remove second-hand smoke and keep fresh in refrigerators. It has no secondary pollution and no consumables. It is very economical and practical. However, when using this type of ozone machine, designers and users generally report that the service life is not very long, so how to check which part is good or bad and how to avoid it, please listen to Zou Gong's explanation.

The core components of the ozone generator are the high voltage package, ozone tube or ozone chip, power management and single-chip program processing. The current power management technology on the market is relatively mature and it is not prone to problems. If it is a product with a single function or a few functions , The BUG of the single-chip microcomputer basically does not exist. We will not discuss the more functions here. The most likely problem is the high-pressure package and the ozone tube or ozone chip. The ozone tube and the ozone chip have a service life limit, at least 1000 hours. If it is found that the surface of the ozone tube or ozone film is dirty, wipe it clean with alcohol, dry it, and test it after 4 hours. If it is normal, the discharge electrode of the ozone tube or ozone film is dirty If it is covered, it cannot be discharged normally; if it fails to discharge normally after wiping clean, it means that the ozone sheet or ozone tube has reached the end of its service life and must be replaced. Another problem is that the high-voltage package is burned out. The high-voltage package is usually all glued. For potting, if there is obvious splitting on the surface where the sealant can be seen, it is very likely that the high-pressure package will burn out. If no burnout is found, it needs to be tested and replaced with a special instrument. In addition, try to buy products produced by regular and experienced manufacturers. The products are more secure. Don't be greedy for cheap. You get what you pay for.

What are the main reasons for the burning of the ozone high pressure package

1): The power is overloaded, and the temperature is too high to burn out due to long-term work.

2): The heat dissipation is not done well, especially for the high-power ozone machine, the long time work causes the temperature to burn out.

3): Most of the high-frequency high-voltage package is in high-frequency and high-voltage working conditions. If the ozone tube or ozone sheet is too close to the high-voltage package, various components and circuits are likely to cause interference, reduce efficiency, and cause the body to heat up and cause the machine to burn.

4): Working in a place with relatively high humidity for a long time will easily cause short circuit of the discharge poles and burnout.

5): Most of the high-voltage package output wires on the market do not have metal shielding. If the two output wires are too close or even tied together, it is easy to cause short circuit and burn when the air humidity reaches a certain level.

6): The two output wire ports of the high-voltage package are too close to the shell, especially nearby metal things, which may cause ignition and overload.